Hi Dan...
it's Windows 98 SE. 320 MB installed RAM (128+128+64). 6.3 GB HD. Only one drive, no partitions.
Did try to run SCANDISK, both in normal and then safe modes. That's when it said there was not enough memory to run surface test.

54% free space on HD.

Ran all the specifics suggested prior to running the Hijack This Log.

Will let Darrell run the suggested changes to the CONFIG.SYS file, I don't mess with that and will let you know what I come up with.

As far as the message in the CONFIG.SYS file, it was in a little window which suggested clicking on a member of the list to run, but there was nothing listed, other than the message about available memory.

Doubt if any of the above helps. Will post back later this evening after Darrell does what you suggested in the config.sys. file changes. Will also try running scandissk/all/surface in MS DOS.

Thank you very much. Beth